VSS Installation Guide Product # 8126VSS
8two connectors together. The two cables will lock together when properly connected. Note: To disconnect the cables, hold both cables by the housing a
9Instructions for Using Velcro®1. Apply the two adhesive-backed Velcro loop tapes to the flat spaces on the back of the console or to the back of the
103. Once plugged in, the console should display the Current Readings screen. If the display remains blank, check if the battery is properly installed
11Troubleshooting section on page 12 in this manual as well as the troubleshooting information in the DriveRight 600E User’s Guide for help.VSS DIP Sw
12TroubleshootingIf your speed is not registering correctly, consult the following check list to help you identify the cause of the problem.• Make sur
13SpecificationsVisit our website for additional product information: www.davis-net.com.VSS Compatibility The DriveRight can work with many different
14Technical SupportIf you are experiencing problems with your DriveRight, first check the cable connections and verify the calibration settings. If yo
© Davis Instruments Corp. 2007. All rights reserved.Product Number: 8126VSS Part Number: 7395.062DriveRight VSS Installation Guide Rev. G (9/13/07)T
1IntroductionThis manual provides instructions and information necessary to install the VSS version of the DriveRight 600E device. Since the specific
2Harness and Adapter Cables Wiring Additional DocumentationRefer to the following documents for information on configuring and using your DriveRight:•
3Installations using Adapter Cable Digital InputsIf you are using the adapter cable digital inputs in your installation, the following additional tool
4• Decide where to install the harness cable and where to connect the power and ground leads — Find a location inside the vehicle where you can bring
5Procedure 1: Install the Harness CableCAUTION: Always use safety stands when working under a raised vehicle. Never work under a vehicle supported onl
6related equipment (headlights, tail lights, air bag, etc.) that you can tap into with an in-line splice. Possible candidate wires include those from
7Procedure 2: Install the Adapter CableTwo digital inputs located on the adapter cable are available to monitor the on/off state of lights, including
Commentaires sur ces manuels