DAVIS Solar Power Kit Manuel d'utilisateur

™SolarPower KitsUSERMANUALDavis Instruments, 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. • 510-732-9229 • www.davisnet.comRSolar Power Kit, #

97. On the back wall of the shelter, look for the embossed outline of a Vantage Vue console and the screw holes marked “VV.”8. Insert the two ½'&

10Mounting a Wireless Weather Envoy in the Solar Power KitNote: You will need your PC to setup the Envoy after you power it up.1. Remove all packaging

113. In order for the Envoy to fit in the shelter, you must move the battery platform.Remove the two screws and washers holding the battery platform i

127. On the back wall of the shelter, look for the embossed outline of an Envoy and the screw holes marked “E”8. Insert the two ½'' #6 scre

13Mounting an Envoy in the Heavy Duty Solar Power Kit (12 Ah battery, #6612)Inside the Heavy Duty Solar Power Kit shelter, you may install:• An Envoy

143. In order for the Envoy to fit in the shelter, you must move the battery platform.Remove the two screws and washers holding the battery platform i

155. Plug the console power cable back into the jack. (It fits only one way, with the latch in back.)6. The battery comes shipped with the positive ca

1610. Plug the main power cable into the Envoy.11. If you are mounting a cabled Weather Envoy, remove the rubber plug from the hole on the floor of th

17Using the Solar Power Kit or Heavy Duty Solar Power Kit with a Universal ShelterFor some installations, you will need both a Solar Power Kit or Heav

18Mounting the ShelterChoose a location for your shelter. It can be mounted on a pole or a flat surface such as a wall or a wooden post. It is importa

1Welcome to Solar Power Kit & Heavy Duty Solar Power Kit (6614 & 6612) The Solar Power Kit and the Heavy Duty Sol

19Mounting on a Post or Flat SurfaceAttach the shelter to the mounting surface in the desired location using the large screws,1/4'' flat was

20Appendix A: Using the Heavy Duty Solar Power Kit with two batteriesYou may add even more power to your devices by mounting two batteries in your Hea

21Contacting Davis Technical SupportFor questions about installing or operating your Solar Power Kit,please contact Davis Technical Support. We’ll be

Solar Power KitsProduct Numbers 6614 (1.4 Ah battery) and 6612 (12 Ah battery)Document Number: 07395.326 Rev. A, February 6, 2013Vantage Pro®, Vantag

2 Contents of PackageSolar Panel and Weather-Resistant Housing Charging Circuit:10’ console or Envoy power cable (back)Battery power cable (middle)S

3The package contains the following:• Weather-proof shelter with solar panel• Hardware kit (as shown)Tools for Setup• Phillips head screwdriver• Adjus

4Mounting Consoles in the Solar Power Kit (1.4 Ah battery, #6614) Note: You may mount the shelter before installing the console or Envoy. However, it

53. In order for the Vantage Pro2 console to fit in the shelter, you must move the battery platform.Remove the two screws and washers holding the batt

67. On the back wall of the shelter, look for the embossed outline of a Vantage Pro2 console and the screw holes marked “VP2.”8. Insert the two ½&apos

7Mounting a Vantage Vue console in the Solar Power Kit1. Remove all packaging material.2. Unplug the power cable from the jack closest to the back on

83. In order for the Vantage Vue console to fit in the shelter, you must move the battery platform.Remove the two screws and washers holding the batte