DAVIS WeatherLink 5.0 Guide de dépannage

Getting Started GuideWeatherLink®Vantage Pro®For Vantage Pro2TMand

85. Guide the data logger cable through the square slot below the receptacle.6. Restore power to the console by reinstalling the batteries and reattac

9The baud rate setting on the console must be same as that set in the WeatherLink software. Use the up (+) and down (-) arrows to change the baud rate

102. At the station console site, put the external modem in a location where it can connect to both the logger and a phone jack and plug it into the p

11Note: The default value for the baud rate setting is 19200. If you have a Weather Envoy, this value should remain the same in the WeatherLink softw

12By default, WeatherLink hangs up the connection to the modem after one minute without any communication with the station. Use the Communications Por

13Note: When necessary, the software automatically dials a phone modem station. By selecting the Walkthrough process, the software displays a series

14Updating Previous VersionsStarting with Version 5.2, WeatherLink has stored additional sensor data in the weather database. Data files from earlier

154. Copy the converted files to your station directory.5. Reopen the station in WeatherLink to view the converted files.Retrieving Data From the Data

16THSW Index command in the Browse Menu, which is displayed when the Browse window is open.Note: Be sure to verify that the latitude and longitude se

17Troubleshooting GuideThe following section answers some of the most commonly asked questions about WeatherLink. Please consult this guide and the on

Product Number: 6510SER, 6510USB, 6540,6544, 6550, 6560 Part Number: 7395.210WeatherLink® for Vantage Pro® and Vantage Pro2™ Rev. B September 2, 2005

18• If the console sends three beeps or the Envoy sends two beeps, See “Commu-nication Port Settings” on page 13 for instructions on checking standard

19• Select Communications Port from the Setup menu. The Communications Port dialog box displays.•Click Loopback.The software searches all standard por

20• The communication port uses a non-standard device name - WeatherLink recognizes serial ports named COM1 through COM10 only. To use a modem, specif

21Next, try clearing the archive memory using the clear dialog box. You will lose any data not already downloaded in your archive memory, but all of y

3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.510-732-9229 • Fax: 510-732-9188E-mail: [email protected] • www.davisnet.comMain Program WindowCtrl

1IntroductionWelcome to Davis Instruments’ WeatherLink®! The data logger and Weather-Link® software let you connect a Davis Vantage Pro®, Vantage Pro2

2Note: WeatherLink is not compatible with the 64-bit version of Windows XP.The amount of space necessary for the data files depends on the archive in

3WeatherLink configuration. 2. Review the Product Features Summary dialog box and click Next. The License Agreement dialog box displays.3. Review the

4The Select Components dialog box displays a selection of the components that are preselected for installation with WeatherLink. The Components List c

5USB InstallationUSB Hardware InstallationThe WeatherLink USB connection creates a direct local connection between your computer and your Vantage Pro,

66. Insert the USB - Mini B connector on the USB connector of the USB data logger. The connection between the console and the computer can be extended

7Serial Port Hardware InstallationA serial port connection can be installed so that WeatherLink uses a direct, local connection between the computer a