DAVIS UV Sensor Manuel d'utilisateur télécharger pdf (Page 13)

Vantage Pro Version: Installation on the Mounting Shelf Page 13

Securing the Sensor on the Shelf

1. Remove the rain collector cone: turn it counter-

clockwise until the latches allow you to lift it up

and off.

2. Place the sensor shield onto the sensor body as

shown here.

3. Route the sensor cable down through one of the

large holes in the mounting shelf.

4. Place a ﬂat washer over the end

of each screw and insert it into

the body.

5. Place a spring over the end of

each screw and hold the

springs in place using a #6

screw retainer.

6. Secure the sensor to the

mounting shelf by driving the

screws into the appropriate

holes as shown.

7. Using the bubble level on the

sensor as a guide, adjust the

sensor until it is level by tight-

ening or loosening the screws.

Note:Final leveling of the sensor(s) should be done with the ISS mounted in its operating location.

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

DAVIS UV Sensor Manuel d'utilisateur Page 13