Davis WeatherLink Getting Started Guide Manuel d'utilisateur télécharger pdf (Page 18)

Troubleshooting Guide

 When viewing data, dashes appear in place of a value for functions other than wind

direction. Why?

If no data was recorded by a sensor (for example, the sensor was disconnected

or radio interference blocked reception) or if bad data was recorded for a

sensor (for example, the sensor was malfunctioning), the software dashes out

the entry rather than showing invalid data. You can use the record editor to

correct these entries.

 The data I want to see, such as humidity (Monitor) is missing completely or is

grayed-out. Why?

All optional sensors must be enabled in the Station Configuration Setup

dialog box before the data will be displayed in WeatherLink. If you are not

seeing data from a sensor that is installed in your weather station, be sure

check the Station Configuration in the Setup Menu and make sure the sensor

has been selected.

1 2 ... 13 14 15 16 17 18 19 20

Pas de commentaire

Davis WeatherLink Getting Started Guide Manuel d'utilisateur Page 18