DAVIS Sensor Mounting Arm Manuel d'utilisateur télécharger pdf (Page 15)

Maintenance Instructions Page 15

Mounting on Top of a Post

In order to mount the Radiation Shield onto the top of a post, you will need the

Radiation Shield assembly (with mounting bracket already attached). You will

need to supply four 1/4” x 1 1/2” lag screws.

To mount the Radiation Shield, simply use the four 1/4” x 1 1/2” lag screws

(not included), to attach the mounting bracket to the mounting surface in the

desired location.

ATTACHING MOUNTING BRACKET TO THE TOP OF A POST

MAINTENANCE INSTRUCTIONS

✦ The effectiveness of the Radiation Shield will be reduced if the surfaces of the

shield become dirty.

Wipe the surfaces of the shield using a damp cloth to remove dirt etc.

✦ Keep areas between Radiation Shield plates free of debris that may obstruct air

ﬂow e.g., leaves, twigs, webs, nests.

DO NOT remove nesting insects or animals by spraying insect killer of

any kind into the radiation shield because this may damage the sensors

and the Radiation Shield.

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

DAVIS Sensor Mounting Arm Manuel d'utilisateur Page 15