DAVIS WeatherLink Guide de dépannage télécharger pdf (Page 11)

REMOTE CONNECTION FOR MONITOR, WIZARD AND PERCEPTION

Hardware Requirements

At Your Weather Station Console:

3. Make a note of the barometric pressure, total rainfall, and (if applicable)

calibration numbers.

You must remove power from the weather station to install the WeatherLink

data logger, which will cause these values to be erased. Use WeatherLink to

reenter these values after restoring power to the station.

4. Place the external modem in a location where it can connect to both the data

logger and the phone jack. Do not turn the modem on at this time.

5. Remove the mounting base from the weather station.

6. Remove all power from the weather station by removing the power adapter

and battery backup.

Failure to remove power before installing the data logger may cause damage

to the data logger and/or station.

7. A small switch on the data logger near the cables controls the baud rate. The

default setting is 2400 baud. If you need to run at 1200 baud, change the set-

ting before connecting the data logger to the console.

8. Connect the short data logger cable to the cable jack marked “WeatherLink”

on the bottom of your weather station console.

9. Connect the blue Telephone Modem Adapter to the external modem.

The Telephone Modem Adapter (#7870) is required to use the data logger with

a modem. A standard DB25 connector with a gender changer will not work.

The blue Telephone Modem Adapter (#6533) supplied for Vantage Pro stations

will not work either.

10. Connect the long data logger cable to the Telephone Modem Adapter.

11. Turn the modem on.

Typical Remote Installation for Original Weather Stations

WL Windows GSG content D009.fm Page 9 Friday, September 12, 2003 12:29 PM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

DAVIS WeatherLink Guide de dépannage Page 11