Product # 7745Daytime Fan-Aspirated Radiation Shield Kit Installation Manualfor Vantage Pro & Vantage Pro Plus Stations IntroductionThese instruct
105. Tuck the cables behind the spacer as shown in Figure 15.. 6. Secure the power cable and solar power cable to the fan plate using the cable clam
11Assemble the Upper Section1. Place the open cap plate (has hole in center) on top of the fan plate, then place the closed cap plate (no hole). See
125. Lower the ISS base onto the stack so that the screw goes into the boss nearest the solar panel.Turn the screw a few times to engage the threads.
13Re-Install the ISS1. Install the rain collector cone and turn the ISS upside down.2. Open the SIM cover and connect the TEMP/HUM and RAIN sensor ca
14Take the Console Out of Setup Mode1. At your Vantage Pro console, press the DONE key to take the console out of Setup Mode. 2. Check the console fo
15TroubleshootingIf you are experiencing problems performing the upgrade or have problems with your Daytime Fan-Aspirated Radiation Shield, first be
© Davis Instruments Corp. 2003-2004. All rights reserved.Daytime Fan-Aspirated Radiation Shield Kit Installation ManualRev B, January 16, 2004Document
2Tools NeededYou may need some or all of the following tools and other items to complete the upgrade: • A medium Phillips-Head screwdriver• A medium
3Installing the Daytime Fan KitPut Console in Setup Mode1. At your Vantage Pro console, press and hold the DONE key and then press the - key to put
4Disassemble the Standard Radiation ShieldNote: We recommend using a workbench or table to perform the following procedures.1.Turn the ISS upside dow
57. Route the RAIN cable behind the drain and out the hole near the drain. 8. Place the adhesive-backed cable tie mount next to the hole near the dra
6Assemble the Lower Section1. The top plate in the ISS radiation shield has a thick, insulating disk attached on the underside. Remove the two screws
74. Start building the lower section of the new radiation shield with the original bottom plate. 5. Place the new Temp/Hum plate from Step 3 and two
811. Lower the Fan Plate onto the stack making sure the screw goes through the boss in each of the plates and lines up with the threaded insert locat
9Install the Fan Unit1. Place the fan unit into the center of the fan plate. See Figure 14. 2. Cabled ISS Only: Because the SIM in a cabled ISS recei
Commentaires sur ces manuels