DAVIS UV Sensor Manuel d'utilisateur télécharger pdf (Page 11)

X-MDA-1™ User Manual Installation and X-320M™ Setup

2.2 X-MDA-1™ Installation

1. Place a nylon spacer over each of the screws

removed previously.

2. Use the screws and spacers to install the X-MDA-1™

adapter board.

3. Connect each of the sensor cables to the respective

modular connector.

4. Install the Analog and Digital cables by running the

stripped ends through the access port of the

transmitter compartment, the same port used for

the Davis sensor wires.

5. Colored tape is used to differentiate each of the

cables when they are attached to the X-320

Xytronix Research & Design, Inc. Page 11

Figure 6: Spacer installation

Figure 7: X-MDA-1 Installed

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

DAVIS UV Sensor Manuel d'utilisateur Page 11