Davis Leaf Wetness Sensor for Vantage Pro2 Manuel d'utilisateur télécharger pdf (Page 3)

TESTING THE SENSOR

You may test the sensor before or after you mount it.

1. Connect the sensor.

2. Make sure you are getting a leaf wetness reading on the console.

Consult the Vantage Pro2 Console manual for instructions.

3. Drop or spray water onto the sensor and make sure the reading changes.

MOUNTING THE SENSOR

Mounting the Sensor On a Wooden Surface

Use the #8 wood screws to mount the sensor on a wooden surface as shown.

Mounting the Sensor on a Pipe

To mount the sensor on a pipe, stake, or pole with outside diameter between

1" and 1-1/4" (25 mm and 31 mm), secure the sensor to the pipe using the 1-1/2"

U-bolts, 1/4" flat washers, and 1/4" hex nuts as shown below. Use a 7/16"

wrench or adjustable wrench to tighten the hex nuts.

Solar Panel

1 2 3 4

Pas de commentaire

Davis Leaf Wetness Sensor for Vantage Pro2 Manuel d'utilisateur Page 3