Davis Universal Anemometer Interface for Vantage Pro2 Manuel d'utilisateur

1UNIVERSAL ANEMOMETER INTERFACE INSTALLATION MANUALWiththisinterface,someanemometersnotmanufacturedbyDavisInstrumentscanbeusedwiththe

10Configure the ConsoleNote: If your are not using an R.M. Young anemometer, you must use a Vantage Vue console. This con-sole allows for the special

11If You Do Not See Current Wind ReadingsRefertoyourISSInstallationManualorAnemometerTransmitter KitManual.Note: It is assumed that the ISS

Product Numbers: 6336©2010DavisInstrumentsCorp.Allrightsreserved.Informationinthismanualissubjecttochangewithoutnotice.Davis Instrumen

2Tools for SetupInaddition,youwillneedsomeorallofthefollowingmaterials:•Adjustablewrenchor7/16ʺwrench•Compassorlocalareamap(toadj

3If you are replacing an already mounted and installed anemome-ter:Remove the old anemometer from its current locationThefollowingtwostepsassume 

4Mount the New Anemometer Refer to the manufacturer’s directions to mount the new anemometer.However,keepthefollowingfactorsinmindasyouchoose

5Mounting on a vertical surface1. Witha3/16ʺ(5mm)drillbit,drilltwoholesapproximately2ʺ(50mm)apart.Useacarpenter’sleveltoensurethe

6Insert the Battery1. Insertthe3‐voltlithiumbatteryintothebatteryholder,matchingthe“+”signonthebatterywiththe“+”signinsidetheint

7Connect the Anemometer Cable to the Interface3-Volt Lithium Battery“OUT” RJ JackAnemometerSelector Jumper(labeled “P2”)IN OUTSolar Panel CableSquare

8Connect the ISS Cable to the Interface1. Feedoneendofthe4‐conductorISScableintothesamegrommetasthe6‐conductorcable.2. Plugitintothe

95. Makesurethatthecableslieflatonthebottomofthecableaccessport.6. Firmlyinsertthefoaminbetweenthecablesandthetopofthecable