DAVIS 8126GD Guide de l'utilisateur télécharger pdf (Page 6)

Using the DriveRight 600E

This section briefly describes the DriveRight 600E display, the use of the

four buttons (PLUS, MINUS, MODE, SET/CLEAR) and the sequence of

Data Screens and Settings Screens. Descriptions of the information and

options available from each screen are explained separately in

“Data

Screens” starting on page 8 and “Settings Screens” starting on page 15.

Note: Never attempt to change the DriveRight 600E display while driving. Safe driving

requires extreme attentiveness. Changing the DriveRight 600

E display while driving

may result in dangerous distraction. Only use the device when you are not operating

your vehicle. Always warn drivers about the DriveRight 600

E’s alarms. If an alarm

sounds, a driver who has not been warned may be startled or get distracted trying to

trace the source of the noise. In either case, it may create a safety concern, so warn

drivers in advance.

Using the Four Buttons

The DriveRight 600E has four buttons: PLUS, MINUS, SET/CLEAR, and

MODE. The general use of each button is explained briefly below:

• PLUS (+) and MINUS (-) — Use PLUS and MINUS to toggle options

On or Off, or to scroll through the ten digits possible (0-9) when

entering a number (usually for entering or setting the Driver ID code, or

changing the date and time).

Also, use PLUS and MINUS to page forward or backward

(respectively) through the stored trips or logs.

• SET/CLEAR — When entering codes, the flashing digit/segment

indicates what will change if PLUS or MINUS is pressed. Pressing and

releasing SET/CLEAR causes the next digit/segment to flash.

From the Driver ID Code Screen, press and hold SET/CLEAR (for at

least 2 seconds) to “log out.” The Driver ID code is reset to 0000. In the

Current Readings Screen, press and hold SET/CLEAR for 2 seconds to

toggle between the two available units of measure (mph and km).

In the Date Entry and Time Entry Screens, press SET/CLEAR until the

entry flashes and use PLUS and MINUS to scroll through the options.

•MODE — Press and release MODE to move to the next data or

information screen. Press and hold MODE to switch between the Data

Screens and the Settings Screens. When the DriveRight 600

E is in sleep

mode, press MODE to “wake” it up.

DriveRight 600E Screens

The DriveRight 600E contains several screens for viewing and navigating

the stored data (Data Screens) and screens for changing and updating the

DriveRight 600

E settings (Setting Screens).

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

DAVIS 8126GD Guide de l'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Électronique des véhicules automobiles DAVIS 8126GD