Davis Vantage Pro Console Updater Manuel d'utilisateur télécharger pdf

Product # 6311

VANTAGE PRO

UPDATER

User’s Guide

Vantage Pro Updater Overview

The Vantage Pro Updater allows you to update the firmware in a Vantage con-

sole via the expansion port used by the WeatherLink data logger. The Updater

can be powered by a 5 Volt Vantage Pro AC-power adapter or a 9V battery. One

9V battery should provide over 20 hours of operation.

Section 1: Using the VP Updater

Updating the Vantage Pro Console Firmware

These are the basic steps involved in using the Updater to reprogram the firm-

ware in a Vantage Pro console.

1. If you are using WeatherLink software with your Vantage Pro weather sta-

tion, be sure to download the weather data into your computer before

beginning this procedure.

2. Press the [DONE] key and the down arrow [-] key on your VP console to

enter setup mode. This will preserve the time and other settings on your

console.

3. Remove power from the console by unplugging the AC wall adapter and

removing the batteries.

4. If a WeatherLink data logger is installed, remove it from the console.

5. Turn the VP Updater on. The Status LED should be GREEN. If it shows

another color, see the Status LED Summary Table.

6. Insert the Link Program Adapter (See Figure 2) into the console expansion

port. See Figure 1 for location of port. It’s the same port used by the Weath-

erLink data logger.

7. Press the Updater Start Button. The LED should start flashing YELLOW.

8. When Updater is done programming, the LED will turn GREEN and you

will hear 1 beep. A RED or YELLOW LED indicates a problem. See the Sta-

tus LED Summary Table and the Troubleshooting Notes for more informa-

tion.

9. Unplug the Updater from the Console.

10. If you have a WeatherLink data logger, plug it into the console.

11. Restart the console by replacing the batteries and/or connecting the AC

wall adapter.

12. Check the release notes for the version of firmware you just installed. You

may have additional steps to perform in order to complete the update.

1 2 3 4

Résumé du contenu

Page 1 - UPDATER

Product # 6311VANTAGE PRO® UPDATERUser’s GuideVantage Pro Updater OverviewThe Vantage Pro Updater allows you to update the firmware in a Vantage con-s

Page 2 - Page 2 Vantage Pro® Updater

Page 2 Vantage Pro® UpdaterStatus LED Summary TableTroubleshooting NotesOn power up the Updater will beep twice and sequence the colors of the LED. Wh

Page 3 - Updater

Page 3Vantage Pro ConsoleData Logger Battery CoverExpansion PortFigure 1. Data Logger and ConsoleON/OFFSwitch#6311Vantage Pro® Updater STARTONStatusLi

Page 4 - Contacting Davis Instruments