DAVIS WeatherLink Guide de dépannage télécharger pdf (Page 12)

SOFTWARE INSTALLATION AND SETUP

Installing the Software

Note: It is very important to follow the order of these instructions. The modem must be con-

nected and turned on before you apply power to the weather station console.

12. Restore power to the weather station console by reattaching the power

adapter and battery backup.

The weather station should beep three times. The third beep, which should

occur within 30 seconds, indicates that the WeatherLink is operating correctly.

13. Place the data logger inside the mounting base.

14. Reattach the mounting base to the weather station.

As you do so, guide all the cables through the slots on the mounting base.

Software Installation and Setup

It is easy to install and setup WeatherLink on your computer.

Installing the Software

1. Place the Install Disk in your CD ROM drive.

2. The install program should start automatically. If the install program does

not start, choose Run from the Start menu, type D:\SETUP (or E:\SETUP,

substituting the correct drive letter for D or E), and choose OK to begin the

installation.

3. Follow the on-screen prompts to complete the installation.

Running the Software

To run the software, double-click on the WeatherLink icon. If you have no stations

in the program directory when you run the software, the software will prompt

you to add a station (see below for details). If you have more than one station in

the program directory when you run the software, the software will automatically

open the last station that was opened.

Note: To get the most use out of your WeatherLink software, please refer to the Weather-

Link Help.

Placing Data Logger Inside Base

WL Windows GSG content D009.fm Page 10 Friday, September 12, 2003 12:29 PM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

DAVIS WeatherLink Guide de dépannage Page 12