DAVIS Sensor Mounting Arm Manuel d'utilisateur télécharger pdf (Page 10)

Page 10 Sensor Mounting Arm

7. Position the U-bolts/saddles on top of the sensor arm on the side farthest from the

mounting bracket so the ends of the U-bolts drop into the appropriate holes.

LIDE

U-B

OLTS

INTO

HOLES

8. While holding the U-bolts in place, turn the sensor arm over so the protruding ends

of the U-bolts are visible.

9. Secure the U-bolts and anemometer arm in place using a 1/4” ﬂat washer, 1/4” split

lock washer and 1/4” hex nut on each of the ends of the U-bolts.

Tighten the hex nuts with your hand so the arm is gently held in place. Do

not tighten fully until instructed to later on.

ATTACH THE U-BOLTS AND ANEMOMETER ARM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

DAVIS Sensor Mounting Arm Manuel d'utilisateur Page 10