DAVIS Sensor Mounting Arm Manuel d'utilisateur télécharger pdf (Page 8)

Page 8 Sensor Mounting Arm

8. Slide the anemometer arm backwards/forwards until the end of the anemometer arm

extends just 1/2” (13 mm) past the second U-bolt/saddle.

OSITION

NEMOMETER

9. Once the anemometer arm is correctly positioned, tighten the hex nuts.

In order to keep the anemometer arm steady in high winds, tighten the hex

nuts until you notice the anemometer arm just begin to buckle underneath

the U-Bolt.

10.Place a cable clamp around the anemometer cable.

11. Slide a #8-32 x 3/4”screw down through the indicated hole on the sensor arm.

TTACH

THE

ABLE

LAMP

12. Slide the hole in the cable clamp over the end of the #8-32 x 3/4” screw.

13. Secure the cable clamp and cable in place using an #8 ﬂat washer and an #8-32 hex

nut.

Tighten the hex nut until the cable is held snugly within the cable clamp.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

DAVIS Sensor Mounting Arm Manuel d'utilisateur Page 8