DAVIS Sensor Mounting Arm Manuel d'utilisateur télécharger pdf (Page 7)

Attaching the Anemometer Page 7

6. Slide the ends of the U-bolts into the appropriate holes at the end of the sensor arm

nearest the mounting bracket.

LIDE

U-B

OLTS

INTO

OLES

7. Secure the U-bolts and anemometer arm in place using a 1/4” ﬂat washer, 1/4” split

lock washer and 1/4” hex nut on each of the U-bolt ends.

Tighten the hex nuts with your hand so the arm is gently held in place. Do

not tighten fully until instructed to do so later on.

TTACH

THE

U-B

OLTS

AND

NEMOMETER

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

DAVIS Sensor Mounting Arm Manuel d'utilisateur Page 7